Rov mk3 Rc Robot Platform - Kit of Parts -RC Battlebot -12v motor -DIY science

Description

Up for auction is a set complete Kit Of Parts (KOP) for the Remote Operated Vehicle (Rov) Mark 3.
Note:  By bidding buyer understand that these are Not toys, and should be used under qualified supervision.  Also, that these rovers should be considered "Works in progress", and are intended as a starting point for your own robotic experimentation.
Kit Includes:
12" X 12" x 1/2"  plywood deck  (x1)
aluminum frame rails   (x2)
18v 900rpm robot/drill motors/transmissions  (x4)
3.5" low traction wheels  (x4)
Motor mounts (front and back) and screws (x4)
HK x-car 45  electronic speed controller (x2)
Clutch locking screws (x32)
red ring terminals #8   (x8)
blue ring terminals #6  (x8)
Interference suppression capacitors  (x4)
Hub washers (x4)
Chuck / wheel locking screw (x4)
Zip tie  (x4)
Barrier strip 25amp (x1)
Wire 18 awg  (x~8ft)
Blue ring terminals #6  for battery (x2)
10-32 tap (x1)
You will need to provide:
Hex wrench for set screws (3/32")
crimper and wire stripper
soldering iron and solder
screw driver #2 philips
Wrench or nut driver
drill bit  3/16"  and optional 1/2"
tap wrench or cordless drill
electrical tape
thread locking compound
12v battery and charger
Radio transmitter and receiver with built in V-tail or elevon mixing (or at least 2 custom mixes) or a external mixer (fingertech tiny mixer)
Mating battery connector and short length of wire
A complete explanation of how to use this KOP to make a basic Remote controlled rov / robot, check out my youtube playlist:  https://www.youtube.com/playlist?list=PL0trvo4-J7IBcAjrtY1MfWdLwj9OUsCaE